Summit O/R H Q

95GTV8

New Member
Jul 25, 2005
386
3
0
Washington State
i just ordered a summit o/r h pipe to compliment my FMS shorty headers that will be arriving soon. I was reading over the instructions that summit provided and i ran into this:

NOTE: you will need to re-use the manifold studs and nuts, and also the original air tube clamp, to install this system. Hardware is included for bolting the rear of the system to your existing exhaust system.

Has anybody had any problems with these studs, nuts, and air tube being damanged beyond re-use? Would it be wise to purchase atleast the studs and nuts new? If the studs/nuts are fine, will they fit w/ the FMS ss headers? I will be putting the headers on, a week or 2 after the O/R H pipe. MY last question is, what is the preferable method of lifting my car for the o/r h pipe install, jack it up & use jackstands, or put it on a ramp and set the e-brake? Thanks for all the help
 
jackstands i'd feel much safer under, just because the force is going straight onto them, and ebrakes can be unpredictable.

the studs are connected to your factory headers, and the nuts screw onto them through the clamp on the h pipe. the nuts and studs shouldn't be damaged beyond re-use, but you may need a lot of WD-40 and elbow grease to get them loose if you don't have an impact wrench

the tube is simply a rubber hose that goes from the metal tubing coming from your smog pump to a pipe on the exhaust pipe. if you're running with no cats, there really is no need to still be using the smog pump and its accesories, so i would say plug the open end of the pipe on your new h-pipe (if it even comes with one) and either dump the smog pump tube to the air or simply get a shorter belt and bypass that accesory