Got a set of 03-04 Cobra 4 lug replica wheels from LMR, these are going on my 93GT with stock spindles, coil overs and tubular control arms.
When I went to install the fronts the grease cup pushes out the center cap on the wheel ?
I tried flattening the grease cup a little but still not enough clearance.
All the info on LMRs site talks about rear wheel clearance issues and maybe rack limiters but nothing about center depth issues.
I could run spacers up front and would only need about 3/16" but just curious if anyone else has run into this issue with these wheels?
Like I said front spindles are stock, the tubular control arms/coil overs shouldn't effect this fitment.
When I went to install the fronts the grease cup pushes out the center cap on the wheel ?
I tried flattening the grease cup a little but still not enough clearance.
All the info on LMRs site talks about rear wheel clearance issues and maybe rack limiters but nothing about center depth issues.
I could run spacers up front and would only need about 3/16" but just curious if anyone else has run into this issue with these wheels?
Like I said front spindles are stock, the tubular control arms/coil overs shouldn't effect this fitment.