two question the first.
1. I recently purchase bellhousing with no bolts.
i need the spec/size on the bolts that bolt the bellhousing to the tranny( t5) and the spec/size on the bolts that bolts the bellhousing to the engine(302).
i have look in the junk yard and could not find any stang with driveterrain. this is my first 5.0 t5 so i never see the bolt size at all.
2. I am putting this motor on a datsun and im going carb for the ease on install.
BUT what electronics goes on a carbed/manual that will need to connect to the chasis ?
IN TERMS OF ELECTRONICS/WIRING.
since its t5 i figure all i need to connect from the tranny is the reverse light.
and starter wire.
and engine i planned to use
manual choke-so no electronic there.
a 1 wire alternator so it connects to the battery only.
the coil
any thing else?
1. I recently purchase bellhousing with no bolts.
i need the spec/size on the bolts that bolt the bellhousing to the tranny( t5) and the spec/size on the bolts that bolts the bellhousing to the engine(302).
i have look in the junk yard and could not find any stang with driveterrain. this is my first 5.0 t5 so i never see the bolt size at all.
2. I am putting this motor on a datsun and im going carb for the ease on install.
BUT what electronics goes on a carbed/manual that will need to connect to the chasis ?
IN TERMS OF ELECTRONICS/WIRING.
since its t5 i figure all i need to connect from the tranny is the reverse light.
and starter wire.
and engine i planned to use
manual choke-so no electronic there.
a 1 wire alternator so it connects to the battery only.
the coil
any thing else?