Well i'm looking at a KB on ebay right now and i'd just like your guys opinion on it and tell me what questions to ask so i get a good used supercharger and not get something old and shot. I asked him how many miles were on it and he said they are unknown because the supercharger came on the car when he bought it. So now i sent him a email about how many miles he has put on it since he bought the car. I also asked him how old approx. it is. It also mounts on the stock lower manifold not the GT-40 intake...
The model number is: TS 1000-5. So which model is the supercharger then? Is it the 1.5 or the 2.2? I know they don't make the 1.5 anymore but this is old so it still could be that 1.5 model.
And he says it has the 7 psi pulley...does that mean he changed the pulley on it? Then what was the original pulley probably?
The setup comes with:
INSTRUCTIONS
7 PSI PULLEY
FMU
SERPENTINE DRIVE BELT
2 A.C. COMPRESSOR BRACKETS
TENSIONER & BRACKET
Supercharger
PROFESIONAL PRODUCTS POLISHED EGR SPACER AND EGR VALVE
BBK 65 MM THROTTLE BODY WITH TP SENSOR AND IAC
C&L COLD AIR ELBOW, 73 MM MASS AIR METER WITH SENSOR AND K&N FILTER
Is there anything missing that you know of?
I know you can't post the link to the ebay auction so if you want to check it out...just go to ebay and type in mustang kenne bell. Thanks.
Heres some pictures....
View attachment 382664
View attachment 382665
View attachment 382666
View attachment 382667
^^^ To me that just looks like the standard kit Which would be the 1.5 or the 2.2 KB(depending on how old it is becuase they dont make the 1.5 anymore)... How about you?
The model number is: TS 1000-5. So which model is the supercharger then? Is it the 1.5 or the 2.2? I know they don't make the 1.5 anymore but this is old so it still could be that 1.5 model.
And he says it has the 7 psi pulley...does that mean he changed the pulley on it? Then what was the original pulley probably?
The setup comes with:
INSTRUCTIONS
7 PSI PULLEY
FMU
SERPENTINE DRIVE BELT
2 A.C. COMPRESSOR BRACKETS
TENSIONER & BRACKET
Supercharger
PROFESIONAL PRODUCTS POLISHED EGR SPACER AND EGR VALVE
BBK 65 MM THROTTLE BODY WITH TP SENSOR AND IAC
C&L COLD AIR ELBOW, 73 MM MASS AIR METER WITH SENSOR AND K&N FILTER
Is there anything missing that you know of?
I know you can't post the link to the ebay auction so if you want to check it out...just go to ebay and type in mustang kenne bell. Thanks.
Heres some pictures....
View attachment 382664
View attachment 382665
View attachment 382666
View attachment 382667
^^^ To me that just looks like the standard kit Which would be the 1.5 or the 2.2 KB(depending on how old it is becuase they dont make the 1.5 anymore)... How about you?