• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Think I ****ed up my stang tonight :(

  • Thread starter Thread starter Nvidia
  • Start date Start date Mar 25, 2006

Nvidia

Member
May 30, 2005
62
0
7
Valencia, California
Mar 25, 2006
#1
  • Mar 25, 2006
  • #1
I was with a few friends earlier and I decided that we were going to go do a burnout since it was 1 in the morning and no one would be up by the industrial buildings.

Basically started cranking it up, and just absolutely peeled rubber for at least 50 feet. Anyway, after I finished and was pulling away among clouds of smoke, something started "flapping" under the car, much like you'd hear if you had a flat tire and you were driving on it.

My original thought was that because my tires run on the inner front bumper corner, during the burnout the car had gone sideways to the point that the bumper was rubbing on the tire, and I thought maybe that had punctured it because it's pretty sharp.

I drove it home, listening to the sickening sound the whole way there as I limped it into the garage. I've let it sit for a few hours and none of the tires look like the've lost pressure at all, which makes me think it was suspension-related and not tires?

The only thing I noticed about the tires was that only the back left tire peeled. The right one didn't. So on the backs, the left has rubber mashed into it, and the right one looks fine.

Anyone have any guess as to what may have happened? Think something's rubbing against one of the tires? I had this sickening thought that maybe one of my shocks broke - I hope I'm wrong.
 
B

bsedwebt70-5.0

New Member
Jul 1, 2004
320
0
0
Charlottesville, VA
Mar 25, 2006
#2
  • Mar 25, 2006
  • #2
Please verify RIGHT vs. LEFT rear wheels - RIGHT is the PASSENGER side and LEFT is the driver side by industry standard but people sometimes get it backwards. I would be curious to find that the LEFT tire spun but not the RIGHT - the right wheel will "peg leg" if your traction lock is worn but not the left - you are saying the left wheel did all the spinning - that would indicate a differential concern for me and it may cause a strange sound inside the rear end to transfer into the body of the car. You may wish to secure the car on jack stands on a solid level surface, put it in neutral and block the front wheels front and back of them to make sure the car does not fall. Then you can spin the wheels to see if a noise is presnent - you may find a bad U-joint (front or rear), internal differential damage, bad motor or transmission mount, etc... You may also need to spin the drive shaft to make the wheels spin to find the noise. Also push and pull on the wheels to see if they move in and out to check for possible axle conditions like bearings, differential problems, retainer problems, etc... I am afraid you may need to pull the rear differential cover and drain out that nasty smelling gear oil and look around with a flashlight to see what is up - If nothing is bad it would be a good time to upgrade to some 75w/90 full synthetic gear lube so all that work would not be wasted - you will do a necessary service and upgrade at the same time you are doing your check. Keep us posted --- oh - also check all your lug nuts for tighness and your brakes.....
 
S

sy1172

New Member
May 11, 2005
175
0
0
Mar 25, 2006
#3
  • Mar 25, 2006
  • #3
I got it, you were being a bonehead!
 

Modular2v

Founding Member
Jun 30, 2002
3,222
23
99
oklahoma
Mar 25, 2006
#4
  • Mar 25, 2006
  • #4
should teach you to stop screwing around on the street. You might want to pull the diff cover off
 

rd

Founding Member
Jan 12, 2000
3,316
63
109
Ocean Springs MS
Mar 25, 2006
#5
  • Mar 25, 2006
  • #5
Jack it up and look over stuff. You may have a piece of tread that has not totally separated yet.

Look at the tires, wheels, driveshaft and stuff near them.

Rotate the axle by hand, etc, while you are under there and listen.

Not a big deal, you break stuff now and then, and just fix it and go again.
 

Euphoric306

New Member
Apr 5, 2004
905
0
0
Mar 25, 2006
#6
  • Mar 25, 2006
  • #6
with all the burnout vids and donut vids and stuff on streetfire and the various other hosting websites, and not to mention in people's signatures, and you're bagging on this guy cuz he did it? he was messing around a bit, broke something, oh well. **** happens. at least he didn't get a ticket for reckless driving or something.

good luck finding your problem bud, but it definitely isn't your urge to have fun with a nice car
 

DeadLifter

Member
Mar 1, 2006
183
2
19
Portland, IN
Mar 26, 2006
#7
  • Mar 26, 2006
  • #7
I was screwin around in a 90 LX I had doin burnouts and got wheel hop and broke an axle tube.
 
You must log in or register to reply here.

Similar threads

B
Electrical Why does my fox body keep frying eecs
  • brandyn200
  • Jun 20, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
259
Fox 5.0 Mustang Tech Jun 25, 2026
AeroCoupe
Progress Thread Might as well start a progress thread on my 92 GT Hatch.
  • Dontknowchit
  • Jun 11, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
28
Views
1K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Sep 8, 2025
Dontknowchit
Engine Suggestions on an engine rebuild. Stock cam/GT40Ps or aftermarket on both for a fun weekend driver?
  • MadSquirrelTech
  • Apr 28, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
23
Views
830
Fox 5.0 Mustang Tech May 7, 2026
MadSquirrelTech
Engine Gas in my oil
  • limp
  • Jun 15, 2025
  • Fox 5.0 Mustang Tech
  • 2
Replies
35
Views
1K
Fox 5.0 Mustang Tech May 16, 2026
Mindseye007
L
95 gt engine vibration
  • lenzgt
  • May 11, 2026
  • 1994 - 1995 Specific Tech
Replies
6
Views
216
1994 - 1995 Specific Tech May 26, 2026
lenzgt
L
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?