I recently Installed an accufab 75mm TB on my 2000 GT. The service engine light came on and was reading low voltage to the TPS sensor which was to be expected but my car is not having any idle issues it is at about 1000 when I first start the car and then drops to 700-800 after a few seconds. Is there something I am missing here or can I clear the code without worrying about it?
Throttle Body Question
- Thread starter archerto
- Start date
loosescrew79
New Member
- Dec 18, 2004
- 313
- 0
- 0
You should reset the computer anyway after you install a part like that. It helps the computer adjust itself to the new mod.
I suggest reseting it and see if it comes back again
I suggest reseting it and see if it comes back again
03ghoststang
Well-Known Member
some people have had to adjust the or move the TPS a tad bit. Otherwise just unhook the battery for like 20-30min and let it re-learn itself
