I bought a set of torque box re-enforcements off of ebay and they are too big. The instructions say you might have to grind down the torque box to make them fit. Anyone else have to do this? Anyone buy re-enforcements that went right in?
I had to make the hole larger, the instructions said that on the 94+ that the hole was actually smaller than the fox holes. I just cut a relief in each corner and bent that section back then after the boxes were in I bent them back to were they were stock, I plan on welding them back together or making a plate to cover the area someday.
Also be aware you have to re-locate the ABS brake line/or E-brake cable (cant remember which one it is, I drilled a new hole just off to the side of were the top plate bolted to, undid the cable and put it down that new hole out of the way.