• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech

transmission rattling

  • Thread starter Thread starter 94Red5.0
  • Start date Start date Jun 29, 2004
9

94Red5.0

New Member
Jun 20, 2004
41
0
0
Jun 29, 2004
#1
  • Jun 29, 2004
  • #1
My transmission is all stock. When i'm in neutral and slowing down to come to a stop the transmission starts rattling. It starts around 15-20 mph and continues down until i'm stopped. This only happens in neutral and when I have it in gear it doesnt seem to rattle. I especially notice it when turning or when i'm next to a car and can hear it echoing off of them. I'm about to get a new clutch (my TOB is out and I need a new clutch anyway) and need to know if i'm going to need to replace anything else while the trannys out so i can remedy this problem as well. Anyone have any ideas before I take it in to get looked at?
 
9

94Red5.0

New Member
Jun 20, 2004
41
0
0
Jun 30, 2004
#2
  • Jun 30, 2004
  • #2
bump
 
9

95GTVA

New Member
May 14, 2006
3
0
0
Jun 14, 2006
#3
  • Jun 14, 2006
  • #3
Rattle in trans Help?

94Red5.0 said:
My transmission is all stock. When i'm in neutral and slowing down to come to a stop the transmission starts rattling. It starts around 15-20 mph and continues down until i'm stopped. This only happens in neutral and when I have it in gear it doesnt seem to rattle. I especially notice it when turning or when i'm next to a car and can hear it echoing off of them. I'm about to get a new clutch (my TOB is out and I need a new clutch anyway) and need to know if i'm going to need to replace anything else while the trannys out so i can remedy this problem as well. Anyone have any ideas before I take it in to get looked at?
Click to expand...


Hello I'm new to stangnet I recently started experiencing the same rattling when rolling in neutral.Does anyone know what the problem is?
 

legalize420

Active Member
May 21, 2005
1,541
1
37
South Florida
Jun 15, 2006
#4
  • Jun 15, 2006
  • #4
hard to say exactly what it could be without seeing or hearing anything. in the past my car would make a clicking noise while coming to a stop or driving slow. it ended up being the u-joints. another time i had a rattle from the tranny and it ended up being the dust cover that goes over the cluth cable/fork was vibrating. i put some permatex around the edge of the cover and that took care of that.
 

chobracobra

New Member
Jun 29, 2004
175
0
0
jersey shore
Jun 15, 2006
#5
  • Jun 15, 2006
  • #5
worn TOB's usually rattle and clank around when your off the clutch. you could try tightening your cable as a temporary fix to put some pressure on it against the fingers.
 
9

95GTVA

New Member
May 14, 2006
3
0
0
Jun 15, 2006
#6
  • Jun 15, 2006
  • #6
Thanks for the response. TOB,s are you speaking of pressure plate fingers?Because it makes the noise whether you push the clutch or not.you also can feel it in the shifter.Thanks again.
 

S/CBlack95GT

New Member
Apr 6, 2003
2,018
0
0
Tampa Palms, FL
Jun 15, 2006
#7
  • Jun 15, 2006
  • #7
My car did the same thing when the TOB was going out. It sounded like I had a diesel engine in my car while I was stopped at a light idling.
 
9

95GTVA

New Member
May 14, 2006
3
0
0
Jun 15, 2006
#8
  • Jun 15, 2006
  • #8
Never mind had a brain problem Know what it is.Throw out bearing.Thanks again Will this also cause a slight vibration?
 
You must log in or register to reply here.

Similar threads

M
85 Capri 5.0 transmission rattle
  • Mamaclean
  • May 2, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
2
Views
247
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- May 17, 2026
Mamaclean
M
00 4.6L V8 new clutch won’t go into gear when on?
  • Timboslice
  • Aug 15, 2026
  • The Welcome Wagon
Replies
3
Views
229
The Welcome Wagon Aug 21, 2026
Noobz347
S
1998 Mustang Gt Rattling sound, cannot locate. Video included
  • studerman1
  • Mar 31, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
8
Views
414
1996 - 2004 SN95 Mustang -General/Talk- Apr 1, 2026
studerman1
S
T
Drivetrain TREMEC TKX 1–2 Grinding Issue at ~4,000 Miles + Poor Warranty/Customer Service Experience
  • Ttopfoxguy
  • Oct 10, 2026
  • Fox 5.0 Mustang Tech
Replies
5
Views
309
Fox 5.0 Mustang Tech Oct 15, 2026
JMG9350
J
D
Mustang not starting
  • Dawry Ramos
  • Sep 12, 2026
  • 2015 - 2023 Specific Tech
Replies
10
Views
391
2015 - 2023 Specific Tech Oct 3, 2026
Dawry Ramos
D
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?