Drivetrain Transmission

[Vicius1970]

Hi all, I have a 1999 mustang GT 5 speed trans, I was driving a couple days ago when I heard a small pop noise and now there is a awful roaring noise that goes away when I push in the clutch, also there is no noise while out of gear, any help would be really appreciated.

 

[weendoggy]

Hi all, I have a 1999 mustang GT 5 speed trans, I was driving a couple days ago when I heard a small pop noise and now there is a awful roaring noise that goes away when I push in the clutch, also there is no noise while out of gear, any help would be really appreciated.

Engine running, clutch in..no noise?
Engine running, clutch out in neutral..no noise?
Driving slowly in gear does it make the noise? and then when clutch in, goes away?

 

[Vicius1970]

If car is running out of gear it doesn't make it,. Once I have it in gear driving it makes the noise then when I Press the clutch to change gears it the noise goes away, when I let the clutch out it starts doing it again,. It almost sounds like when you has a card in a bicycle wheel

 

[Vicius1970]

And at low speeds it's the same with clutch in no noise, once back in gear and let clutch out the noise starts back

 

[manicmechanic007]

You are going to need to pull the trans out and replace the broken or cracked bearing
Input bearing most likely
You need to think to yourself
What changes in the trans when you push on the clutch?
The input bearing quits spinning
It likely has a cracked outer race
Real common
Good luck

 

[weendoggy]

Agree with 007 that the trans must come out. Replacing the sleeve is easy on a T45, and very obvious if cracked. Inspect that clutch while there, no sense in pulling it twice if it's worn.