hi, i have a 95 cobra 23,000 miles and stock except for 3.73's, offroad h, cat back, and the tri-ax. my problem is that i have occassional 3rd gear grind when i shift into gear but even before i take my foot off of the clutch. i adjusted the stops to make sure it is going all the way into gear and it definitely is. i don't think the stock shifter was doing this but i only had the car for a very short time before i did the swap so i'm not sure. any ideas what could be causing this? i guess the next move is to put the stock shifter back on and see what happens.
tri-ax/trans help/question
- Thread starter SVT3183
- Start date
94TURBO5 O
New Member
Sounds like stretched clutch cable or your tranny 3rd is getting ready to take a crap so be light going into 3rd or you may hear a "snap, crackle and pop." Then shortly afterwards annoying clunking. 
Try changing the clutch cable or if you have an ajuster twist than in some.
Try changing the clutch cable or if you have an ajuster twist than in some.
Not to insult you, because I've done the same thing, but there is a possibility that you think you've adjusted the stop enough and indeed you haven't.
Try pulling the screw all the way out and drive it. This should only be done temporarily, as it's hard on the transmission.
If that doesn't work, I'd suggest checking the fluid level in the trans.
If that doesn't work, then it's time to split the case....
Joe
Try pulling the screw all the way out and drive it. This should only be done temporarily, as it's hard on the transmission.
If that doesn't work, I'd suggest checking the fluid level in the trans.
If that doesn't work, then it's time to split the case....
Joe