So this weekend I hooked up my wideband to the egr input on the eec. I was told it was pin 27. So I spliced a wire from the output wire on my wideband and then spliced it into pin 27( its a brown wire with a green tracer) So after setting it up in binary editor under the hardware tab and setting up the payload i went to datalog. But it doesnt work, the afr values stay at a constant 20 and sometimes switch to 19 or 13. I cant figure this out. If anyone could give any suggestions I would appreciate it. Thanks. I was thinking maybe its the wrong wire or something, but I dont know what wire to use. Cause theres three wires coming off of the egr.
-Justin
-Justin