unmetered air???

86turbo

Member
Apr 8, 2006
183
0
17
hey guys i have an 85 coupe that i just put an efi 302 in. I have the nipple on the valve cover capped off but i have an open breather element in the rear of the intake where the pcv usually goes.......

anyone done this?

Drew
 
If you have the nipple on the VC capped as well as the nipple on the throttle body and you do not have the PCV connected to the vacuum port on the underside of the intake then you should not have an unmetered air issue. You would only have an unmetered air issue if you were running a pcv system connected to a vacuum port on the underside of the intake. This would allow the engine to pull air through the breather on the VC through the PCV system thus bypassing the MAF.

That said have in just a breather in place of the PCV valve is not the best setup for evacuating corrosive gasses from the crankcase.
 
thats exactly what i thought, just wanted to double check. The breather isnt enough to evac the crankcase??? I have a catch can with the same size breather on my turbo 5 liter and even with seeing some blowby ive never had the vc gaskets blow out or anything.......elaborate please.

Drew
 
The PCV system evacuates the crankcase by drawing in clean, metered air and expelling it through the PCV into the intake plenum where it's burned, versus introduced into the atmosphere. A breather system only allows the crankcase to remain at atmospheric pressure, but doesn't introduce clean air into play. Either one works, but the PCV system is more efficient.
 
thats exactly what i thought, just wanted to double check. The breather isnt enough to evac the crankcase??? I have a catch can with the same size breather on my turbo 5 liter and even with seeing some blowby ive never had the vc gaskets blow out or anything.......elaborate please.

Drew
The fact that the VC hasn't blown a gasket, doesn't tell you much.

Put a vac gauge on the crankcase and go for a drive :nice: