V3 install

[flints82]

I am installing a V3-SI on my 88 GT.Also i am converting to MAF at the same time.I want to run between 8-12psi.I would like some info on what size injectors,which MAF meter I need to use.I have a C&L 73mm housing already.I am a new member and have been reading on this but I need to buy these parts and dont what to buy the wrong ones.

 

[Mike in Texas]

V3

Are you setting this up to race or more daily driving. 8-12 psi is getting into some serious boost and horsepower.

 

[flints82]

Both! I want to be able to drive & can drive with some driveability issues but I only want to buy these parts once. I've done an SC set-up on my 1977 F150 but it is a roots 671 with dual carbs. I had this motor built for this much boost and I want to use it to its full potential. Any advise is greatly appreciated.

 

[Mike in Texas]

V3

Fuel Injector Calculator from WitchHunter Performance will help you with the injector sizing provided you can make a fair estimate of your fwhp. I stayed with the 24#ers and FMU because I like it for daily driving. I had to change from a C&l to Pro M maf when I installed the SC to get a decent idle. One more thing, DYNO TUNE after you get it all together!

 

[flints82]

Ok Thanks for all your help.