Valve float

5.0stang_gt

New Member
May 8, 2005
62
0
0
Hey I have a 1993 mustang gt with bolt-ons and they don't have to do much with this topic, but the other day I built a side exhaust for my car with straight pipes and my question is there enough back-pressure to not have valve float and what type of noise would I hear if it was. Also what valve springs and rocker arms should I get for a minor modified car with a goal of 350 hp.
 
Valve float really doesn't have much to do with exhaust backpressure but rather valve spring pressures combined with how aggressive a camshaft is in its ramp rates along with high rpm usuage. You really need to know what camshaft you are going to run. Then answer what type of rpms are you going to rev to. Only then can you determine how much closed/open spring pressure you will need.

Btw, when one has valve float, the valves are actually doing just that. You are basically hanging them open while dumping raw fuel out. You are making very little power at this point not to mention asking for a valvetrain-related problem (stock 5.0 HOs usually started to exhibit valve float in the 5500 rpm range I believe).