Indiana New Member May 6, 2004 286 0 0 Oct 12, 2004 #1 Oct 12, 2004 #1 Every post I've read about installing cams says that by far the worst part is installing the locks. Has anyone used this tool from comp cams?: I'm not sure if there would be enough clearance with the spring compression tool. I'd be willing to drop a few more dollars to save a few hours.
Every post I've read about installing cams says that by far the worst part is installing the locks. Has anyone used this tool from comp cams?: I'm not sure if there would be enough clearance with the spring compression tool. I'd be willing to drop a few more dollars to save a few hours.
stang9gt Founding Member Dec 21, 2001 1,247 0 0 State College, Pa Oct 12, 2004 #2 Oct 12, 2004 #2 won't work on an OHC motor unless the cams are out of the motor