Vortech Superchager

[VibrantRedGT]

Buddy and I installed this in my garage in a few hours. Actually he did most of the work while I was at work. Vortech supplies a book with blown up pictures. You can't install it wrong. No tapping the pan is a huge bonus. Only problem is it's low boost out of the box. However the wick can be turned up in need be.

 

[StreetsideStig]

I love how simple these are. Post some video if you get the chance!

 

[5LiterWes]

Buddy and I installed this in my garage in a few hours. Actually he did most of the work while I was at work. Vortech supplies a book with blown up pictures. You can't install it wrong. No tapping the pan is a huge bonus. Only problem is it's low boost out of the box. However the wick can be turned up in need be.

Nice rig, what kind of supercharger inlet tube is that?

 

[lxman]

Lol i used the dyno at UTI! It made 252 horsepower is and 309 torque. Untuned too, plus running a little lean. I normally use the dyno at my work. Those are good numbers for my base line to start with for my engine build. Once build is done with supporting mods im shooting for 475ish.

 

[lxman]

I would post pics of the build and dyno sheet but i cant figure out how to upload it from my phone. I will try from my computer at home tonight after work.

 

[VibrantRedGT]

Nice rig, what kind of supercharger inlet tube is that?

That's a UPR Power Pipe made in plastic. It's about $100.