Im not a huge 94-95 fan (sorry I guess I shouldn't have said that over here) while I love the cable arrangment, that elbow sucks limits flow when you get to a high hp level and is always in the way for valve covers.
No comparison between those two intakes...
Yes definitely getting another tune..are you going to take it back to the dyno then?
Right now we have the lower on and set the upper in place with a spacer.... no egr... Had a small spacer on the cobra, it might work looks a little high but we will see... The intake is a little smaller then the Cobra and not close to hitting the tower brace.The intake is taller, but the elbow brings the throttle body back down to stock height so long as you don't run a phenolic spacer. I was able to get that intake to fit without a spacer by using the Trick Flow valve covers. I shaved a negligible amount of metal off the bottom of the upper plenum to get a little bit of clearance between the plenum and the valve cover. In retrospect, I'm not sure if it was even worth it. You can get a used set off of ebay for under $100, and they aren't that expensive new. If you are still running an EGR valve though, that will be a bit of a problem. You should be able to get it to work with a little bit of love though.
Kurt
Bought the trickflow elbow.if you can run without a spacer try that it keeps the intake as short as possible and hlep with the upper rpms, what elbow did you get ?
Had a 1/2" spacer on the cobra.... Good to know about the spacers.... have one coming tuesday.I have two 3/8" spacers somewhere. The actual throttle body is designed to end up in the same location when the elbow is installed. I guess you didn't have a spacer on your Cobra, si this one will be .375 higher.
Kurt
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?