Warped aluminum heads?

Grn92LX said:

You need to talk to a machine shop then, you sound lost. Do you even know what a clean up mill is or does? A clean up mill will surface the deck as much as it takes to be 100% true. Could be .040" could be .002" you won't know until its done/checked. If it gets clean up milled enough, it'll raise the compression enough to gain some ponys. Mine needed appx .015" to clean up taking me from 57.6cc to 55.6cc.

I wasn't trying to say your stuff is small, I was saying mine was bigger and cleared fine. My old fti cam was VERY small for my liking but it was also designed to spin a tad higher than yours. I made sure not to make that small cam mistake on the new motor.

Click to expand...