Went to the track last night.... good numbers

I got me a set of 1.75" BBK Long tube headers on the car finally So i drove out to the drag strip last night and made one pass on it before they told me i couldn't run anymore, i didn't have a helment. Any way the slip went down like this:

Reaction: .0183
60 Ft: 2.0053
330 Ft : 5.452
1/8 ET: 8.268
1/8 MPH: 88.81
1/4 ET: 12.7230
1/4 MPH: 111.17

Thats with my 275/50 BFG Radial T/A out back and all bone stock 20 year old suspension with the front sway bar removed.
What do you guys think?? What will she put down with a good set of slicks? Any suggestions also welcome. BTW, i Was shifting at 6300 rpms Thanks

I was on my BFGoodrich street full treaded regular radial T/A's
I didn't have any drag radials with me so that is why the ET's are low. I was spinning 1st, 2nd , and 3rd gear. I really had to feather the clutch out of the hole to keep the tires from going up in smoke.

My motor is a 90' 351W block bored .030 over
Keith Black flat top pistons
stock crank and rods and oil pump
AFR 61 cc 185 CNC ported heads
Comp cams extreme energy cam 284/296 .541/.544 lift
Hardened pushrods, guide plates, 1.6 roller rockers
Out the box performer RPM intake
Holley 750 DP 71/80 jets
BBK 1 3/4 full length headers, mac prochamber, mac mufflers, ss tailpipes all 2.5"
All stock suspension, T-5 tranny stock shifter, King cobra clutch
Stock 8.8 rear with 3.73 gears and built trac-lock
Full interior 3300 lbs with me in it and a half tank of gas

Thats the setup