What all parts are needed for PI intake swap?
- Thread starter 98blackstallion
- Start date
well i will try the "t" fitting thing and if doesnt work there is always the side of the block correct?
mr. jones1
New Member
on my 98GT I did not need the nipple. just 2-o-rings.
Don't forget the web site for picks and instruction.
www.unitedmajority.com
there is a pic of the sensor tap with details on
where to buy it. I have not tapped a plastic crossover, this does
sound risky. You could probably find a manifold for (alum. crossover) $160 on e-bay look for a seller called the "stangstore" or try www.mustangtuning.com @ $198.00 for a manifold.
The tee fitting should work but the reaction time will be slow due to the sensor not sitting in the flow path.
Don't forget the web site for picks and instruction.
www.unitedmajority.com
there is a pic of the sensor tap with details on
where to buy it. I have not tapped a plastic crossover, this does
sound risky. You could probably find a manifold for (alum. crossover) $160 on e-bay look for a seller called the "stangstore" or try www.mustangtuning.com @ $198.00 for a manifold.
The tee fitting should work but the reaction time will be slow due to the sensor not sitting in the flow path.
Similar threads
