What cam and pushrod to use???

[seandig]

Im building a 351W.. I have everything except a cam/lifter kit and pushrods.
Its a 10:1 compression, .030" over 351W with edelbrock victor jr heads with 1.6 roller rockers, performer rpm air gap intake, holley 750 dp. I would like to use the valve springs that came in the heads, but will change them if i have too. I would like to go mechanical flat tappet. nothing roller. I wanted something in the 230's for duration, and high .500" to low .600 lift, but cant seem to find anything..

Any suggestions...??? what lenth push rods do i need?

 

[vristang]

Measure the pushrod length when you have the cam/lifters/rockers.


If you aren't going the cheap-o route, then look into Camshaft Innovations (see link in my sig)

jason