Crane springs, good for .560 I think. Heads arn't done yet. I'm hoping they flow about 210/170 at .500. I'm hoping to not mill the heads much, if at all. I don't want the compression ratio much over 10.0:1.
I currently have a Steeda #19 I could use, but I was looking at the CompCams grind 35-351-8 XE270HR 114 degrees \w .512/.512. I also have 1.7 cobra rockers. That would put the lift in the .545 range. The 35-324-8 XE270HR grind for 1.7 rockers has the same specs but on 112 degrees. Neither say that they will pass emmissions. All I need is to get the engine in and have it fail emmissions, then have to pull the cam.
From what everyone has said on here over the years, if you tell FTI that you need a cam to pass emmissions, but still make good power, they can help you out.