what heads should i get

[351mustang65]

what's the best 351w heads i can get for around $800? here or some that i have been looking at http://motors.shop.ebay.com/_Car-Tr...-heads_W0QQ_nkwZ351wQ20headsQQ_fxdZ1QQ_ptasZ1 i would like to do roller cam lifters and rockers but don't know if i can afford them yet

 

[PUNISHER RACING]

Street car , Race car whats the rest of the recipe?

 

[rbohm]

you can pick up a set of world products windsor sr heads in cast iron for about $900 ready to bolt on.

 

[351mustang65]

Street car , Race car whats the rest of the recipe?

fast street car not going to stroke it or anything just a Performance rebuild kit with flat tops edelbrock performer rpm air-gap intake headmen swap headers and hopefully roller rockers lifters and cam

 

[351mustang65]

do you guys like any of them heads on ebay?

 

[351mustang65]

thanking maybe this set http://cgi.ebay.com/ebaymotors/ws/e...tToStoreCat&refwidgettype=cross_promot_widget

 

[351mustang65]

or this 1 http://cgi.ebay.com/ebaymotors/FORD...191652047QQcmdZViewItem?hash=item300191652047 or do you think i would be better off with some heads from summit like trick flow twisted wedge dart brodix world products edelbrock victor jr. edelbrock performer rpm

 

[D.Hearne]

Save your money for better quality heads. Both those you listed have "thin" decks. The 1st says they have .200 thicker, but in actuality they're .200 thinner than US made heads. (.400 vs US heads which run from .626 to .750) Notice on those "thick deck heads, the seller conviently omits the manufacturer's name. You can find good quality US made heads, which aren't the highest flowing, but will still give the motor a wake up call for $600-800 (used heads) I bought a set of GT40Y's last month for $600 and at the same time ran across a set of Edelbrock RPM heads for the same price. Be patient, half the fun is the hunt. Check the classifieds here, there's always good stuff for good prices in it.

 

[D.Hearne]

Also check out "Thumper's heads" he sells here in the classifieds, neverheard anything bad about his work. His heads are ported E7's.

 

[valley firearms]

heads

I found my TFS heads with the proper length pushrods on another classified board. I don't want to mention another site in this post but I would be happy to forward it to you in a PM. There are always good deals on aluminum heads and plenty of them. Here are mine that I paid $900 for. You could save your dough and buy the new edelbrock pro port cnc heads.​

http://www.edelbrock.com/automotive_new/mc/heads/pdf/flow_data.pdf