What intake gaskets?

Felpro is good. Check summit for gaskets for your motor.

ur local autozone or advanced will have felpro or mr gasket just bought some today i blew a head gasket

get cobra intake gaskets also forgot to put that in there

here you go Matt...this is all you need...just go pick one up at an advanced or autozone...you might have to wait a day if they dont have it in. Also that is the gasket set I used and it worked great. Just do a mixture of RTV and the Blue Rubber gaskets on the end otherwise it is known to leak if it is just the gasket.

http://www.partsamerica.com/ProductDetail.aspx?MfrCode=FEL&MfrPartNumber=MS95952&PartType=102&PTSet=A

I like the Felpro brand

I use an install method that is a bit different than most
but
I don't have any issues such as leaking and the like

I use no glue or sealer on the gaskets

I do use the cork end gaskets

I glue them down to the China Wall with 3M Weather Strip Adhesive

I then use a pea sized dab of RTV on each of the 4 corners

Use some all thread or old bolts with the heads cut off to guide the lower
down nice and straight which keeps the side gaskets from slipping around.

Be sure to retorque all bolts until they obtain an even amount of tightness

This will take anywhere from 3 to 5 times to get the job done

Also ... after a couple of heat cycles ..........

You W I L L find some bolts have lost their original amount of torque
so
It is a M U S T to recheck A L L bolts to ensure they are good and tight

Grady