What is the 95 Mustang stock ride height

[Methodical]

What is the stock ride height (front and rear) when measuring from the fender to the ground? I need this information so that I can properly install my MM CC plates. Thanks

 

[TheDamned]

Check in the owner's manual

 

[95cobraguy]

4x4

 

[wytstang]

Not sure but from what I've read it's 2much

 

[Yobi1Kanobi]

Its up there between high and higher

 

[Methodical]

Can someone provide a number?

 

[94-302-vert]

I would say that any number is still relative. My front end dropped 3" when I put on my C-Springs... that ain't right...

So why do you need this to install C/C plates? They jsut bolt in place. No height adjsutment for the plate itself then for the strut it is just to make sure the strut doesn't hit the hood right?

 

[95cobraguy]

why dont u just call mm?

 

[Methodical]

I would say that any number is still relative. My front end dropped 3" when I put on my C-Springs... that ain't right...

So why do you need this to install C/C plates? They jsut bolt in place. No height adjsutment for the plate itself then for the strut it is just to make sure the strut doesn't hit the hood right?

Because it helps in the placement (i.e. height) of the strut shaft in order to gain back bump travel from lowering the car so much. In other words to keep from having the strut shaft to low and bottoming out on the internal bump travel.

I did call MM and they provided me with some assistance

 

[wytstang]

Why not just count the treads before removing the CC nut you have, then just bolt it back down with the same tread count.