What is this intake fitting for?

TheBocSez

New Member
Feb 3, 2004
652
0
0
Converse, TX
I am Installing a 93 Cobra intake on my 91 LX.

On the lower intake at the passenger side rear is a nipple fitting and I dont know what its for. Best I can figure is its where the coolant line would connect if I was still running an EGR spacer with coolant running through it.

I have also bypassed the heater core by removing the metal heater tube that runs along the intake and relocating the ECT to the front passenger side of the intake where the heater tube used to connect.

On the front drivers side, I have connected the fitting for my aftermarket water temp sensor.

At the drivers side rear is a hole that is plugged.

So, should I plug the hole in the passenger rear also or does it serve some other purpose?

Thanks.
 
TheBocSez said:
I am Installing a 93 Cobra intake on my 91 LX.

On the lower intake at the passenger side rear is a nipple fitting and I dont know what its for. Best I can figure is its where the coolant line would connect if I was still running an EGR spacer with coolant running through it.

I have also bypassed the heater core by removing the metal heater tube that runs along the intake and relocating the ECT to the front passenger side of the intake where the heater tube used to connect.

On the front drivers side, I have connected the fitting for my aftermarket water temp sensor.

At the drivers side rear is a hole that is plugged.

So, should I plug the hole in the passenger rear also or does it serve some other purpose?

Thanks.

Plug the pass. rear.

Everything else sounds ok.

I take it your ECT threaded right into the front pass. location?
I have wanted to move the heater outlet to the rear, but was concerned about the ECT not threading into the lower intake.


jason