What Is This Line For?

Assassin 5.0

Member
Dec 19, 2014
20
2
13
IMG_8971.webp
I know the picture isn't the best but it's all I have at the moment ... I have some arrows pointing to the line. It a hard vacuum line hose that comes from inside the firewall...it's not connected to anything in my car I just have it tucked into the fendewell... anyone have an idea what it's for or was for?
 
Well the charcoal canister and associated components were deff. Removed prior to me owning the car.... I just read a little on this and it's coincidental that I also do have a Raw fuel smell coming from under the hood and I've been trying to find out where it's coming from... now that I know what this is... this may be the issue.
 
  • Like
Reactions: Davedacarpainter
Well the charcoal canister and associated components were deff. Removed prior to me owning the car.... I just read a little on this and it's coincidental that I also do have a Raw fuel smell coming from under the hood and I've been trying to find out where it's coming from... now that I know what this is... this may be the issue.

It is. I once routed mine into the air intake tube so it sucked the fumes back in.
 
So is it possible to cut and shorten that long tube and re-route it into the vacuum system somewhere without consequence or will I have to reinstall the canister system?

I would not do that. IIRC: The original system worked under pressure from the tank with a solenoid that would open to relieve the pressure and run it through the charcoal box to eliminate the smell. I hesitated to go to vacuum route because I worried about pulling vacuum on the fuel tank and possibly sucking fuel through the line. That may not happen but that was my reasoning.

FWIW my 2010 f150 used a evap switch that vented the tank to the vacuum system. It worked well until the switch failed and stuck open. This caused a vacuum leak directly to the tank and some of the owners reported that the truck pulled enough vacuum to collapse the tank!
 
Last edited:
  • Like
Reactions: RaggedGT
Cap line (rear of car preferred)

Install vented gas cap
How does this eliminate his fuel smell? FWIW, I have my line dumped the same exact way as the OP and I have zero smell regardless of temperature. I wonder why it's different for some than others.

edit: I see that the OP is supercharged. Is it possible that the OP has too large of a fuel pump and a lot of heated fuel gets returned to the tank which may cause higher evaporation of fuel and more vapors to vent?

@Assassin 5.0
 
How does this eliminate his fuel smell? FWIW, I have my line dumped the same exact way as the OP and I have zero smell regardless of temperature. I wonder why it's different for some than others.

edit: I see that the OP is supercharged. Is it possible that the OP has too large of a fuel pump and a lot of heated fuel gets returned to the tank which may cause higher evaporation of fuel and more vapors to vent?

@Assassin 5.0

Your line could be kinked or clogged. Id say you might be correct, the more fuel you move the more it will create vapors. I would think that the more fuel you keep in tank the less you will smell it. Who knows..... I have similar experience. One car had gas vapor smell the other one didnt. My 87 notch didnt have the gas smell until I noticed the line was kinked.. I cut it beind the kink and then I could smell it... So I put a rubber line on and drilled a small hole into the rubber intake tube and forced it in so the smell went back into the engine...
 
How does this eliminate his fuel smell? FWIW, I have my line dumped the same exact way as the OP and I have zero smell regardless of temperature. I wonder why it's different for some than others.

It doesn't. It just mimics how cars from the 60s used to run it before the EPA mandated all hydrocarbons must be emitted from the tailpipe only, so they plumbed it into the engine.

as to why his smells and yours doesn't? Maybe his purge vskve on the tank is stuck open? Maybe his fuel pump is too big and circulating the fuel to the engine and heating it up causing expansion? Perhaps the fuel smell is unrelated?

But basically the OP has three options.

Reroute the line to where it can vent better.

Cap like and vented gas tank

Reinstall canister and set it up like factory

I know what I would do but the decision is his to make.