What is your stang getting for x-mas??
- Thread starter Spro
- Start date
SaleenGT2001
Well-Known Member
'13_ImpactBlue_GT
Angry Little Elf
Fr500 steering wheel
172/154cfm PI heads w/ comp cam springs
VT cams
New PI intake manifold
SCT X-Cal II bt Tim @ MPH
FRPP head changing kit
6 quarts of synthetic
Coolant flush
1 - TUBE ASY- HEATER WAT
1 - Thermostat, f150, w/supercharger - f150 1997-03, heritage 2004 (4.6l, 5.4l) 1999 180 degree
1 - HOSE ASSEMBLY-HEATER
1 - BRKT-ALT SUPT
1 - Valve cover gasket, mustang, left - 4.6l sohc 1996 - 1998
1 - Valve cover gasket, mustang, right - 4.6l sohc 1996 - 1998
2 - Manifold gasket, all models, sohc 2003 - 2004
8 - AWSF-12C's
Damn Red
Spend that $
How much will the Fr500 steering wheel set you back
CobraRed_96_GT
Active Member
ThanksDamn Red
Spend that $
How much will the Fr500 steering wheel set you back
Should be about 165-170 for the steering wheel. My dad bought it for chistmas present, they said they shipped it to me, never did. Turns out it was out of stock. So he's just giving me a "gift certificate" to buy it or something else.
They used to be $149, but they went up like brakes did
'13_ImpactBlue_GT
Angry Little Elf
CobraRed_96_GT
Active Member
my stang has a driver's side air bag on the wheel, when you get the FR500 wheel you transfer the bag onto the new wheel - it'll be two tone like my interior (tan/black)
the98stang
Active Member
Chrome 18x9 and 18x10 saleen rims with 295 tires out back...sitting in the garage
Plus something from my gf.....
Plus something from my gf.....
snap, a third time.
No such thing in an npi
lol, you would say that!
BTW, broke something in the car. The motor is leaning real bad, checked the motor mounts and they look fine. I dont know what it is, Im gonna have to get it on a lift. Baytown may be a no go.
Just to let you know, my mounts went bad at 108k and I replaced them with cheap factory replacements--not the "upgraded" version that Ford offers since I figured if the stockers made it 100+ that the replacements would do the same....not so lucky, I get a mild pop on start up 
Let me know when you figure out the problem. We are having a pretty good turnout on Sunday.
Let me know when you figure out the problem. We are having a pretty good turnout on Sunday.
geoffsgt
Member
Twista
Active Member
hotmustang331
Active Member
DCjuggalo
Member
CobraRed_96_GT
Active Member
blackfang
Founding Member
Flghtmstr1
Member
I finally got the money together (and will hopefully have the time) to transform my car into something I can be proud of and happy with 
FRPP 3.73s
bearing kit
trac-lok rebuild
FRPP aluminum driveshaft
FRPP C-Springs
Bilsteins
MM CC plates
MM Panhard Bar
MM LCAs
Cobra steering shaft
Magnapack catback
Accufab 75mm TB/Plenum
Cobra brakes
Rear spoiler delete
winter tires
Also, if I have the time, a built 4R70W and B&M Hammer shifter.
Many of the parts listed above are already in my possession, but I've been away at school and therefore have not had any time (or proper facilities) to install them.
When I graduate, I'm going to buy myself a 2.1L KB as a graduation present
FRPP 3.73s
bearing kit
trac-lok rebuild
FRPP aluminum driveshaft
FRPP C-Springs
Bilsteins
MM CC plates
MM Panhard Bar
MM LCAs
Cobra steering shaft
Magnapack catback
Accufab 75mm TB/Plenum
Cobra brakes
Rear spoiler delete
winter tires
Also, if I have the time, a built 4R70W and B&M Hammer shifter.
Many of the parts listed above are already in my possession, but I've been away at school and therefore have not had any time (or proper facilities) to install them.
When I graduate, I'm going to buy myself a 2.1L KB as a graduation present
Similar threads
