What rocker studs for Eddy RPM heads?

[NKau]

I picked up some edelbrock RPM heads at a swap meet a while back. They have the 6025 casting #, and supposedly have the 1.90 intake valve. Just curious what sized rocker studs I need? Can't come to a clear conclusion, even after checking edelbrock's website, and summit doesn't list them specifically for these heads, or any others for that matter. Thanks.

 

[NKau]

Anyone?

 

[DMAN302]

Sorry no..but what did they cost you???

 

[maverick0716]

3/8" studs

 

[NKau]

3/8" studs

3/8" top and bottom? The only ones I can seem to find are 7/16" at the base and 3/8" at the rocker; hence my confusion. Also, does it matter what length they are? Thanks.

Oh, and DMAN, I snapped the heads up for around $670 or so.........without studs, guideplates, etc. Still not too bad of a deal, even with all the monkeying around I'll have to do I figure.

 

[DMAN302]

Good grab on the heads..they will be a nice addition.