what should i be running?

[spideys85gt]

ok here it goes-ram air, 73 mm mass air, 65mm tb and spacer, edelbrock performer upper and lower, 1.7 rockers, x 303, msd pro billet dist., blaster2 coil, 9mm wires, elec. fan, pullies, equal lenght shorties, off road h, flows, 4.10's, 5 speed, ports and polished heads with windsor valves, alos has solid motro and trans mounts. what do you think my time is gonna be around?

 

[spideys85gt]

ttt

 

[shttygtstang]

i think that cams to much for the motor tb too small for the cam time will hit high 13s low 14s

 

[spideys85gt]

well i've got quite a bit of gear for the cam, talked to a guy at ford motor sports on the phone for quite some time about it and according to the specs he said the cam should rock with the gears and heads. what size tb think i should go with?

 

[shttygtstang]

you also need air to flow with it or its use less with more air you need more gas time for some 24lbser .your bottle necking

 

[spideys85gt]

ohh yeah i've got the 24's on there i forgot to add that, so would you say 70 or 75 mm tb?

 

[shttygtstang]

i say 75 but it would free up horse power but a 70 would do the same but seems like your trying to mod so witha 75 youll have room to grow and wont need one in 5 months

 

[shttygtstang]

but then your 73mm maf
is to smalll for a 75

 

[spideys85gt]

ok, so what do you sugest? this is my first EFI motor so i wanna do it right as i go. and would you sugesst going with a CAI over a march ram air kit?

 

[spideys85gt]

bump

 

[bluevenom867]

Is that on a stock short block?

 

[spideys85gt]

yeah it's all on my stock short block componets

 

[IndyBlk5.0]

hard to say. However, 65mm is fine, dont upgrade until you NEED it. You don't need it right now.

 

[NKau]

I don't see anything wrong with the 65mm TB either. Get it to the track and find out. Good luck.

 

[spideys85gt]

ok well do you guys see anything wrong with my cam/gear combo either?