What size bolt is holding the harmonic balancer?

[The Green GT]

I dont have a socket big enough to fit the bolt on the HB and I want to make sure I get the right size. And what do I have to tourqe it down to when Im done?


Something else i noticed. You never realise how big stuff is untill you actually have it off the car.

 

[VibrantRedGT]

15/16th's

 

[The Green GT]

15/16th's

thanks

 

[The Green GT]

ok how the HELL do I get the bolt out. I have my car on ramps, e-brake on, tranny in 1st gear. AND IM MOVING MY CAR. I knew I was strong , but this is insane.

 

[legalize420]

put it in fifth

 

[legalize420]

110-130 ft-lbs

 

[The Green GT]

O man I dont think Im gonna get this one off without a breaker bar.

 

[legalize420]

if you dont have one, try the handle from the floorjack over the end of the socket wrench.

 

[The Green GT]

if you dont have one, try the handle from the floorjack over the end of the socket wrench.

Well I got the bolt out with just the socket wrench *flexes muscles*
But im guessing I need a wheel puller to the balancer off?

O and no floor jack either.I usually do this stuff at my buddies house and my car was kind of stuck here. So I just put it on ramps and went at it.

 

[final5-0]

But im guessing I need a wheel puller to the balancer off?

No

Use a hb puller!

You don't even want to hose up the threads in the crank snout

Grady

 

[The Green GT]

Ok Im pretty sure its not my HB now. The rubber piece is flush all the way around. Now I need to figure out what the **** is wrong. I could have sworn it was the HB. This sucks.

 

[VibrantRedGT]

What was the issue? Did you have a vibration in neutral (no load)?

 

[The Green GT]

What was the issue? Did you have a vibration in neutral (no load)?

Vibration throughout the whole band.
http://forums.stangnet.com/showthread.php?t=618282