I used some overlays from www.whitegauges.net They were pretty easy to install. The slip on over the gauges. I have not installed the complete replacement type but it dosnet seem like it would be too hard. After the cluster is out, its only 4 or 6 screw holding it on. The most important thing is that if you have to remove the needles, make sure you take a pic of exactly where they were or they will read incorrectly. Also, while your at it, it would be a good time to take the needles and lightly sand the white paint off the back and replace it with red or orange. I went to a local crafts store and bought one of those orange paint markers, 2 coats and it looks great. Makes it a lot easier to read during the day.