who is using sn95 springs?

[SVO1]

From what I could find I think Bhuff, and not sure who else.
How much trimming did you do?
I have line on a dirt cheap set of c springs for an sn95 and I am thinking they would work well in my 87
Thanks for any insight!

 

[Mustang5L5]

C springs are not SN95 specific. They are actually 79-04 Springs and will work in all Mustangs.

I have a set in my '88

 

[SVO1]

Mike- Thanks!
Was thinking that but wa snot 100%.
I just know he said they were a gift for his 95 but he dedcided they were too stiff and took them out
So I think i gotta call him tomorrow !

 

[chaka]

I have them in my 79. it is BB'd with one coil cut in front I could place one finger between the fender and tire. Tall in the rear. Haven't cut any coils out back yet.

 

[bhuff30]

Mike- Thanks!
Was thinking that but wa snot 100%.
I just know he said they were a gift for his 95 but he dedcided they were too stiff and took them out
So I think i gotta call him tomorrow !

yup, they shuold work. Brantley is running C springs. I know that Wish cut them down some to lower it a little, but I don't know how much. Expect a harsh ride.

 

[SVO1]

Harsh is good Give all the ladies a back ache riding with me!

Seriously tho, I hope to jack the car up a bit, the stock springs are so worn the car sits about 2 3/4 lower than stock, and it handles like a wet bag of ****!
(plus unless you drive it on blocks you can not get a jack under it)


Figure I should get my baby back together right so we can start a new life out together.

 

[Lx89Stang05]

i have 94 corba springs, and there cut, people say you get a hard ride but i like them stiff since i autocross,i wish they where harder

 

[Red_LX]

I got some SN95 springs for my Thunderbird....just haven't put em on yet.

As a side note, on my '90 I put 5.0 springs in the front and '84 TC springs in the rear. Musta lifted the car at least 2 inches

 

[mr_woodster]

<center>2" , i laugh...try this one on for size...

 

[Red_LX]

<center>2" , i laugh...try this one on for size...

Some guy out around here had a '70s Corvette just like that. Primer black and sitting on a Blazer frame with 38's or 39.5's under it.

 

[nomuffler]

I had Eibach sportlines that came off my dad's '00 Gt, it went down an inch with no cutting. They work great, the rear shocks from his car worked great as well.