Wideband O2 Installation

Like I said in the other post I'm getting ready to install LT headers and h pipe from JBA and installation of a wideband O2 sensor and gauge. Has anyone here installed one on an 05-06 before? If not I need wiring diagrams. Thanks

Nevermind guys I talked to a few people at SCT and other tuners. This new wideband controller only requires running the wire to the wideband. The power comes from the cig lighter. So no need mount the gauge and run the wires. I figure I hook this up through the shifter and tune the A/F ratio and then unplug it and cap the bung off. Its also cheaper than getting a wideband gauge and other hardware. The guys at sct said that this is one of the best products out there.

Check the site:
http://www.innovatemotorsports.com/products/lm1.php

Yeah, well I figured that most A/F kits are around 500.00 and this way I don't need to mount a gauge and run wires. I know how to but this way is easy and cheaper. Also I can use it on other peolpes cars and make a little on the side.