will a 10.5 slick fit on a 10 hole wheel and with that fit under an 89. it is 28 inches tall. is that too much does anybody know if this will fit or not.
With enough fender rolling and inner fender hammering, also with the quad shocks and tail pipe gone, it will, but you'll still get rubbing with a 28 inch tall tire, but it'll probably be ok at the track. That tire would be better on a Weld with the right amount of back spacing. Also you're running a pretty wide tire on a 7 inch rim, which you could prevent if you had 8 or 9 inch Welds to use.
Yes a 10.5 tire will fit on a set of turbines or 10 holes. The 28" tall will cause you to have to roll the fenders, but the other stuff shouldnt cause any issues.
As long as they are et streets and not et drags they will work. THe et drag 10.5's are almost 12 inches wide. You won't have to do anything with your tailpipe or the quad shock if its still there, the only problem is the height and you still might get away with it as long as you don't have GT ground effects.