Will my mods get me into the 14's?
- Thread starter NEEDA5.0
- Start date
I would venture to say yes. You have 4.10s that’s going to help you out tremendously. You need to find some traction and bring those 60' down. Hell advance the timing it free hp, lower rear tire pressure to 25 psi inflate front tire psi 40, remove front sway bar(install after you finish racing), remove some weight pass seat, rear seat,ect... good luck.
slvrbullit302
New Member
I agree that a good set of tires either ET streets or a set of drag radials will get you in the 14's with no problem.
Well the answer is no. The best I could get was a 15.42 on drag radials. This is getting ridiculous. The freakin Diablo chip cost me 2/10's. It shifting at all the wrong rpms, like holding 1st to 6200 and 2nd to 5800. I turned the chip off and still couldn't get past 15.42
I know the vert is heavy and all but I'm getting frustrated.
I know the vert is heavy and all but I'm getting frustrated.
mystang94gt
New Member
Man are verts really that much hevier? I ran 15.2 when my car was bone stock, not even a k & n air filter. And that was street tires and stock gears by just pressing the brake and launching at like 1500 rpm's. How much do those verts weigh?? I would think you should be able to pull 14's no sweat with the stall converter. What were your 60 ft times like??? Did you lower the tire pressure in those d/r's to like 15 psi? They wont hook up unless you lower the tire pressure and roast the **** out of them to get em nice and sticky.
hrmmm...i think you need to buy my cobra intake when i take it off . i think you should get pretty close to 14's. im hopin you dont have ur stock hpipe on there. if so then you need to buy a new one and ill put it on for ya 
. i think you will be close tho. after my second gear gets fixed, i want to go to the track bad
. i think you will be close tho. after my second gear gets fixed, i want to go to the track badI'll take your cobra intake off of ya when you're ready as long as your available for technical assistance with the install. Yes, the factory h-pipe is still on. 
I'm waiting for the great state of Illinois to send me an emissions notice before I take it off. I know as soon as I take it off its gonna come.
I'm waiting for the great state of Illinois to send me an emissions notice before I take it off. I know as soon as I take it off its gonna come.i hope i don't have the same trouble NEEDA5.0. i just got my cobra intake installed and am waiting on the 4.10s as well. looking at your signature, by the end of next week, i'll have everything you have minus the subs(got control arms), stall and the chip 
i ran a 15.4 @ 92 my first time out, hope with these mods the times get a lot better.
send pm on chip
i ran a 15.4 @ 92 my first time out, hope with these mods the times get a lot better.send pm on chip
