hey guys in the midst of prepping my car from the fender bender i just had, i have been moving a few wires to the fenderwells for a cleaner look. one of those things is the fuse box and assorted wires which go to it. it is still in a place i can service the fuses should they decide to blow, but since it isnt an everyday thing for them to blow i figure it wont hurt for me to have to do a bit of work to replace them. the second thing i am wanting to do is move the wires from under the airbox into the fenderwell on the pass side. if i move the ignition control modular to the fender and bolt it on behind the fender instead of right where it is at will it cause any kind of driveability problems? or will it be alright since it is still mounted to the fender?
will this be ok?
- Thread starter Mac-man
- Start date
SeventyMach1
Keep it lubed .... keep it straight .... and keep
I have never done anything like this.... but plan to. I guess I could try to point you in the RIGHT direction.... try to PM Scott (mo_dingo) or Mike (oinkaodeoink). I hope they don't mind I said that. They have done an excellent job with cleaning their bay's up and I'm sure they know the preferred location for the module......
i havent either, but have been messing with it. i was able to mount the ignition control module in the same location but on the other side of the fender, so it isnt able to be seen. the car started up fine, but since it has no fenders,bumper or lights i didnt think it would be good to drive it down the road. i hope that works
Similar threads
