window trim prep/paint

NKau

Founding Member
Dec 15, 2001
1,346
0
37
Jefferson, WI
I should be able to pick my car up from my paint guy any day now, but I still need to get all of my trim cleaned up and repainted. For the regular metal window trim, I was thinking of just scuffing with brillo pads, then painting with a low gloss engine enamel as per instructions from my paint guy.

For the rear quarter windows (with the rubber mouldings), I still need some definite advice as to what to do. They are not hardly pitted, but the finish is super dull, and I'd like to take care of them before they get any worse. I do have them pulled off of the car if that will help. Do I need some sort of flexible paint, or even a primer after sanding these? What grit sandpaper should I be hitting them with? Thanks.
 
I have to do mine also but mine are pitted to hell. I'm thinking about using some 3M bumper repair epoxy to fill in the pits... since that stuff should remaine flexible.

As for paint, I'm not sure... urethane based paint stays flexible... Maybe those cans of bumper molding paint would work...???
 
I used flexible bumper paint on the metal trim and the quarter window trim. That way it all matches and you don't have some parts glossier than others. I used satin black. For the metal trim use a Scotchbrite pad or a 320 grit or finer flexible sanding sponge to scuff. 3M has these new sanding sponges that are great and last longer than sandpaper. You can just vacuum them clean when they start to clog. You can get them at Auto Zone or Walmart. Brillo will probably be too coarse. If your quarters are not too pitted you can use flexible bumper primer to fill tiny imperfections. You will need several coats. Then Sand smooth and paint with several light coats. Mine were pitted pretty bad, so I filled them with Evercoat Polyflex. Not the easiest stuff to work with, but they turned out great.

I forgot to mention, I always wipe everything down with alcohol to remove any waxes or oils before I apply the paint.