Windstar Swap Now Wont Pass Emissions Has Codes

2000 mustang v6 windstar intake swap is done and driving it..but here in pa we have an annual safety and emissions inspection this car isnt going to pass the emissions test part of it...
it has a code P0401 ...I think thats it....its an egr code reading low...
i did use the egr from the windstar as well and made sure it was nice and clean..

but again i have a code but not a check engine light

i have read ALL the threads and stickies on ALL the different websites and most of the links dont work any more ...i need a diagram on where the vacuum lines are supposed to be
i'm kinda shootin toward not getting enough vacuum to the egr ...when i disconnect it i can feel it pulling but i'm wondering if its enough....or.....

maybe its not even a vacuum issue also i'm thining that the hile in the intake is clogged ...cause i know the egr is good.....anyone know where i should start?

well no i have no idea if they are reversed.......cant seem to find ANYONE who has actually done a CORRECT vacuum routing diagram........i mean there might be one out there on one of these sites but the posts are so old and outdated the links no longer work..
as far as the egr being removed and blowing through the tb didnt try that....guess i should
As far as exhaust or vacuum leaks...none and 100% positive on that......especially vacuum i used water and carb cleaner.....


and there is no driveability issues...runs perfect idles perfect......

also on another note....mil came on today for the P0401 code so its still going on...