manual

So my 1984 5.0 didn’t pass emissions due to the EGR valve not opening or closing at all I’m looking for a diagram for the vacuum lines for it or any ideas of what’s going on?

Hello I’m new on here but I had a question I have an 88 gt Mustang stock t5 can but I’m doing a maf swap and I have a A9P computer I’m wondering if I can use it to ad the maf sensor even with the stock manual harness? I was reading something about the o2 sensors but I also see it will be just fine

Up for sale is a 2014 Mustang GT in Grabber Blue. This car is a 6 speed, manual transmission, base trim. This car is modified, albeit slightly. Modifications are primarily cosmetic, along with the common things like exhaust, suspension, tint etc. All modifications are from reputable brands such...

I know, I know. Another guy with the wrong parts trying to make it work. Well… I did make it work. Sorta. I have an 89 lx 4cyl that I swapped in a 93 5.0 along with the 93 ecu and harness while keeping the 89 body harness. With some wire jumping I did get the car to run and drive great with the...

I have a 1998 GT 4.6L SOHC, i was on my way home from a concert and my belt was squealing and i was slowly losing power and it ended up dying, assuming it was the alternator cause that has been an issue in an older car, i got a new alternator, jumped the car and still no good, the car holds...

new here, my name is nicole and i currently own a 2002 5 speed mustang gt. she was an auction find, had 134k miles when i bought her now has 145k. my issue is, when i cold start the engine, it’ll idle high then drop, idle high then drop. the rpms get up to a grand, then drop to a little under...

Hello all, I’m pretty new to the forum and this is my first post. I have a 2004 3.9 V6 and I swapped the upper intake manifold from a 4.2 onto it. I pretty clearly made a mistake, as my car now thinks it is at 18% throttle position (checked with live feed obd2 reader) when I’m completely off the...

My speedo gear popped loose in my transmission the other day. I can stick my finger in the hole and I can feel the gear towards the back of the tail housing, but I can't feel the little metal retaining clip. Do I need to take this thing apart again and get it out? I'm kinda afraid it will find...

Hello. Tore apart my transmission and found some concerning things. Here is my 1-2 slider (be ware) This is one of the most chewed up sliders I've seen. I don't even know how this got this way... Synchro was fine. Probably because previous owner beat the hell out of it. Other side (1st gear)...

I need help trying to decide what the best option is for my transmission. Its a 1993 lx 2.3 swapped to a 5.0. The tranny is the original t5 WC and it needs a rebuild (whining, bad syncros, oil looks like a pound of glitter was poured in). I've done some research and it looks like I've got a...

Hey all! i just recently replaced my shifter with a short throw and love it! But about a week after install, my 5th gear began whining. It's only in that gear, when i shift to 4th at the same speed ~55mph, it goes away. I haven't heard this before the swap but it also didn't happen immediately...

I know this topic has been done to death, but I have a problem that I cannot seem to relate to any other threads. So my t5 only whines in 1st and 2nd. All the other gears act like any other transmission. The previous owner rebuilt the engine, but got the transmission built by someone else. He...

So about a month ago, I noticed this chirping noise coming from my engine bay. At the time, it only happened right when releasing the clutch pedal and accelerating in gear, didn’t matter which gear, and sometimes it would happen when revving I’m neutral, without touching the clutch pedal. And it...

all right I got a 97 mustang 3.8 L V6 that cranks and barely sputters when you tap the gas. if I don’t tap the gas it will just crank. It has spark and fuel pump kicks on. spraying some starter fluid in it makes it act like its flooded. The antitheft light comes on for one second then goes off...

Does anyone have a pdf or a link to one of the original ford factory service manual? I have the Haynes one but I know Ford used to make an official one that I've found on multiple sellers. Problem is, the physical books are almost $100 each. Found here...

Howdy boys. Just bought a ‘17 3.7 6-speed and I’m having trouble smoothly shifting from 1st to 2nd. I’ve had manual cars before but this is my first manual mustang. I find that if I take off slowly then I can shift smoothly from 1st to 2nd but when ur at a light who has time to go that slow...

Hi Everyone, :coff: My name is Paul and I live in Reno, NV. I used to own an 89 GT Hatchback in the 90's when I was in my 20's and then got married at 25 and had to sell her due to moving to San Diego and the stricter smog policies. She was slightly modified without cats and that was around...

I have a vortech supercharged 2006. It's pushing 460 to the wheels and 450 tq. I want to get it to around 600, however, I know there are measures I need to take before then. I was wondering if these steps were reasonable. On 10psi from 3.6 pulley. Long Tube headers and X pipe in a two weeks...

Hi everyone. I just bought a used 2012 5.0.with 69k miles. I love it, but I ran into an issue today. It’s almost like the safety feature for reverse is broken. If I push down on the shifter, it doesn’t let me go passed the lockout and up into reverse, but instead puts me into first gear. If...

Researching these forums has been really helpful for me, so I'll leave some details of my trans swap to maybe help others down the road. Car 2001 GT Auto - 1st owner, 60k miles. I bought most of the following parts 10 years ago, and then took a break from modding the car while my kids were...