mustang

I have 1990 mustang gt and I'll be driving and everything is okay but let's say I'm in 5th gear if I go into neutral to coast the rpm rise to 3k, sometimes even stalls. I bought a new iac and fuel filter and I haven't stalled YET but I haven't drove it much , but it's still rising in rpm to 3k...

My 2002 V6 mustang won't start. It began right after I got home and now it just clicks a single time (starter). I started troubleshooting by checking the starter relay & fuse, replacing them with no luck. Then I tested the battery myself and it read 12.4V with the car off, not bad but this...

new here, my name is nicole and i currently own a 2002 5 speed mustang gt. she was an auction find, had 134k miles when i bought her now has 145k. my issue is, when i cold start the engine, it’ll idle high then drop, idle high then drop. the rpms get up to a grand, then drop to a little under...

is it possible to change my old 4 gauge to a 6 gauge on my 2007 mustang v6 has anyone ever done it before like i notice the 3 dummy buttons on the radio bezel that doesnt do anything but the wires are still there like if was a premium or gt or something i seen old threads saying they did it but...

Selling my 1988 Ford Mustang GT $8800 History of the car: It is a Florida vehicle that I bought when I was 16 back in 1998, it has never seen any winter use since I bought and brought to Minnesota. Upgraded the engine throughout high school, added nitrous, different set of frame connectors and...

Hello, Was hard to get into first gear so had Mike's Transmission in McKinney Texas install a new clutch kit for my 2005 V6 Ford Mustang. He said that he used the MOOG kit. Ever since the kit was installed there is a Rattle or Vibration Noise coming from the transmission while the car is...

Replacing the capacitors in your Fox Mustang EEC? Here is the quick and dirty info you need so that you don't have to look all over the place like I did. I watched every YouTube vid I could find on replacing these 3 caps. I also watched plenty of “how to replace capacitors” in general. I have...

Hi there everyone, I have a 1999 Mustang GT Limited Edition 35th Anniversary. 1 of only 250ish made in white with a convertible and a automatic, around 90,000 miles. Unfortunately the car is in need of a lot of cosmetic work but it serious sound mechanically, she has a dented rear left quarter...

I own a 91 foxbody and need to replace the oil pan gasket. I know how annoying this is going to be because it's old and the gasket will need to be scraped, and if I don't lift the engine and just replace it through the small clearance the old gasket parts will fall into the oil pan when scraping...

How hard is it to drop a new long block 4.6l into a 2001 Mustang GT. I have some nasty bottom end rod knocks and just would rather put a new engine in myself. I know I'll need to get an engine cherry picker, and probably some new tools but I have a lot of tools available to me. My question is...

Ticking right up under the driverside valve cover, gets quicker with rpm, and sometimes you hear a flutter of around 5 in a row instead of just a single tick. I have already pulled the lifters and pushrods out and checked and they looked fine also no loose rocker arms. I have also tried thicker...

So I have the fuel injection leftovers from a couple of engines I acquired and before I throw it away, does this stuff have any value?? Fuel rails, injectors, intake manifold, the large top of the intake manifold, etc? Any help here or any idea on the value?? Parts are from a 98 Explorer...

NOTE: CANNOT GET TO PASS SMOG IN CA I am selling my 2002 Stage 2 (Supercharged) Roush Mustang. The car has an Allen M90 Supercharger with 30LB injectors and BBK cold air intake. Miles: 74,000 Original miles Model: True Stage 2 Roush (#6328) Pros: Low miles Great body style Dyno'd at 350 HP...

Recently did new coils and spark plugs. Upon inspection I noticed I didn’t have any coolant in my reservoir for my heat exchanger. Therefore added some royal purple ice and proceeded to drive it and noticed misfires and fluttering as if combustion was effected. I checked the coolant and it’s...

Ok guys im kind of worried that I may have dug myself into a pretty deep hole. I recently purchased a 1996 Cobra with 100k(ish?) for a good price I would say (the odometer is stuck at 100631, but judging by interior it doesnt look far off). I am learning stick on this car as well. It seems I...

Hello all, I recently bought a 2019 Mustang GT. One feature i did not try while at the dealership was the remote start. The car had 8k miles on it when I bought it so I figured there would not be a problem. So i tried the remote start numerous times and all I get is three flashing lights on the...

Alright so today I just drained the fluid from the pan and did the pan gasket when I went to fill up the transmission I added fluid into the dipstick and it just sat for a second didn't drain down and started to overfill when the funnel was raised is it possible that the dipstick can get clogged...

Got a 1994 gt, gonna have the bottom end rebuilt and balanced with new pistons, rings, bearings, etc.. and bored to a 306. I'm sold on the Trick Flow 170 twisted wedge heads unless i can find some reviews about the enforcer heads AFR rolled out. I'm trying to build a mostly street car. Hot...

I found a guy selling this project car. It's a 2000 Mustang with an '04 Mach 1 engine swap, with 136,000 miles on it. It needs new struts, which I can do fairly easily, and some other cosmetic work. All is sound with the vehicle mechanically, as far as I know. So, I ask, is this car worth the...

Hello, I recently got flagged by the State of California for Smog issues on my vehicle. They are requiring that I put the "factory" tune back on my car. The issue is that I have a true 2002 Stage 2 Roush mustang and I am not sure what the factory tune is! Is it still a basic 02 GT Tune...