no start

Recently got a 1984 5.0L, M VIN. 79,000 miles. Edelbrock Carb, mild cam. No spark from coil to distributor. So far I’ve replaced (in order): battery, ignition control module, ignition coil, & ignition pickup/stator. Confirmed 12v to the ignition coil and that all spark plug wires are...

Been on this form and YouTube for the past 2 days looking though all similar items. Recently bought a 90 Notch, smog delete, header, intake. What happened: I buy the car in NC no issues, drive it around for a few months, drive it to IL. After about 2k miles I change the Oil. *I pulled the...

Hi guys, I’m new to foxbodys and this platform. I have an 89 LX 5.0 5-speed. Not much history on the car but what I do know is: Cam and lifters done(no specifics) BbK headers and cutback exhaust Upgraded alternator Problem is I was driving car would cut out half a second 2-3 times on my 30...

Hi first time posting. I have a confusing headache of a problem that I can't figure out. I have a n/a 2.3 engine and a4ld trans from what I believe was a 1993 mustang in a Joyner frame. It cranks but won't start, fuel injectors aren't getting a pulse. Here are the details: Spark: tests good...

So, I took the car to a welder for floor pans, got the car back and I had to get a new battery… Got the new battery, fixed the terminal connections. I’m running into an issue now where the car won’t start. I am able to start the car by creating a connection with a screwdriver to the solenoid.

I recently went down my list and fixed almost everything that needed attention on my 86. I replaced the radiator, added an electric fan, thermostat, hoses, water pump, AC clutch, brake proportioning valve, air intake, transmission cooler, and serpentine belt. I went to start it today and it...

Hi all, 1994 V6 Mustang, bone stock electronics. I was driving and the car completely shut off. On the side of the road I had a crank no start. After a tow home I see fuse E in the engine bay is blown and has continued to blow as soon as key is switched on. It controls - PCM - Fuel Pump - O2...

I did a 351 swap into my 95, with the swap I change to the fox body throttle body, I'm trying to get the car to start, it just over, I'm getting fuel to the rails, I'm getting spark from to the plugs, but the plugs still look new like they are not trying to ignite. any suggestions would be...

Something is draining the battery, then when I get the battery charged the car will start then rough idle and stop if I hit the gas. I'm usually not able to restart it at that point. While its running I pull the p1233 code. I've already replaced the FPDM and the CCRM but I'm still getting the...

Having troubles starting my 03 gt 4.6 , I get cranking but no firing. Hooked the scanner up for the live stream while cranking and my MAF reading stays at 0.09 lbs... After cranking the car I’m hearing a air leak near the firewall by the passenger side. I’ve wiggled the hoses to see if the...

Hey guys. Me again. 93 2.3L cranks but wont start. So here is a little history. Had issue with car bucking and loosing power after driving a little. Then it quit and would start back up like nothing was wrong. It hadn't been serviced so I installed the following. Plugs (x8) Wires Coils Fuel...

Hello, my car was running fine and I was lazy so I disconnected my battery to clear my ECM codes as I have done before. When I plugged the battery back in the odometer showed all dashes, the security light came on and now it only cranks. The OBD2 port also doesn't seem to work anymore. I should...

I'm working on swapping an engine from a 93 GT into an 85 4 cylinder car that was carbureted. The wiring harness and ECU is an A9L from a 91. The fuel pump is a generic CarQuest inline pump. We had it running, but after hooking up the electric fan it won't start. I unhooked the fan and it...

So I was performing maintenance on my 99 v6 3.8 this past weekend, I replaced the valve cover seals and lower and upper intake manifold gaskets. Reassembled the engine completely and started it up. Car ran for approximately 15-20 while I was bleeding the coolant system. I loosened the upper...

All I’m getting is a single click when trying to start up my fox. I’ve checked the battery it’s good and I’ve replaced the ign switch as it was getting loose. This is my daily and it happened minutes after it was cranking perfectly fine. Below a video that shows me testing at the solenoid. Goes...

I was driving down the highway in my 2002 mustang gt (138k miles) on my way to work when all of the sudden my car lost power. The car cycled on and off very quickly and i was able to drive home. I put the car neutral and let it sit for about an hour. When i tried to start the car again there was...

Hey, guys! New to the forum. I know someone must have answered or attempted to answer this question before. I purchased an 88 Ford GT 5.0 convertible from a guy who could't turn a wrench. Last season the car would fire right up on a cold start, hot start not so much. I have changed the ignition...

I am absolutely confused and infuriated with this problem. I have not seen any other threads that describe an issue anything similar to this, so here goes. For the past few days, my car has been starting perfectly fine every time. It has no hesitation starting, and it seemed to run quite well...

Hey what's up guys, Im new to the forum here. So here's my dilemma. I have a 1986 GT 5.0 That keeps shutting off. You start the car up, it runs fine, sometimes for a few minutes, sometimes for a few seconds. Sometimes it will shut off on its own, sometimes it will happen if you press the...

Hello all! I am the proud new owner of a 2005 GT vert I purchased used from a dealer. This will be my 2nd mustang. However when I purchased the car it came with an extra key fob. The fob is on both key sets. And I presume it's an aftermarket security system. There's a button on the center of it...