Hey everyone, I have a 2000 mustang gt and I’m looking to give it a little more power. I’ve looked into supercharger kits and the likes but I’m just not sure what the most efficient way to get to around 400whp is. If anyone could help point me in the right direction id greatly appreciate it.
Hello
I purchased an 89 GT couple years ago
it’s a Density Car.
Worked out a bunch of electrical bugs with all yours helping.
basically a daily driver and fairly reliable
no real mods except Rear end clutch refresh with the extra shims for better hookup.
no more 1 wheel peel!!
anyway,
My...
I was going to work this morning and the car lossed power and stalled, happened once before. Tried to crank right after but nothing. Waited a minute, fires right back up drives fine.
Could this be a fuel issue somewhere?
Hey everybody I just recently got a 2000 mustang gt and am looking to give it a little more kick, but I'm relatively new to the upgrading scene and not 100% sure what I should do to bring those numbers out of the v8. This is why I've come here to ask for you're all advice, please keep in mind...
Hi Everyone,
I literally signed up for this forum, for this specific issue. I have a Mustang EcoBoost 2015. As most of you know the door is frameless (in regards to the window) which is why the window has an automatic short drop to clear the rubber lining when opening and closing the door...
Hey guys i have a 97 cobra with a vortech s trim , running 10 lbs of boost , dyno sheet says 440whp , im not the original owner of the car but want to turn the boost up , so im curious what the rear end will handle , i dont know if it has any axle or diff upgrades , unless some
One can tell me i...
Hey guys, I’ve looked all over and can’t seem to find what I’m looking for.
I have a 89 engine and harness I have swapped into a 1980 Toyota pickup ; ( my snow wheeler ). I have main 12v per supply to the computer, but, I have yet to figure out which wires are to the ignition for Run and start...
I have a 1994 Mustang SVS (recently acquired) with a fuel injected V6, which I removed and replaced with a carbureted 5L. I’ve used a Performance World distributor in this conversion; it uses a single power wire for its power source. I used the positive wire from the EDIS coil to feed the...
Hi guys, so I’m relatively new to this forum and I would like to hear from some people who can tell me a little more about what would make my car reach 300rwhp. I would like to start of by saying I don’t want nitrous oxide or any boost. I just want naturally aspirated. I don’t plan on any...
Hello, I have a 302 mated to a T5 world class 5 speed transmission that had roughly 1000 miles before the car was wrecked. Everything on the engine was new when it was built. I will include a picture of the build parts. Its under an engine hoist ready to go and be dropped into your muscle car...
Hello, I have recently purchased a 2001 Mustang GT with a Saleen supercharger. One problem is that when it is cold it pulls hard and runs perfectly. However, when it warms up, it starts to skip and miss a lot. It just has a really inconsistent power and doesn't open up all the way when warm...
Hey guys!
I have a guy offering some $50 E7TE heads from a 95 302 and I was curious if they will fit on my 1970 302 block. I’m running an Edelbrock performer intake and Edelbrock 650cfm carb with hooker headers and everything else is completely stock. I’m planning on porting the E7TE heads out...
I've heard there are methods for tuning the 2014 V6 Cyclone so that the power band begins somewhere around 1 or 2k RPM instead of the stock 3k. Is this true? (I assume there is some truth to it because there is a forum prefix called "Digital Tuning"). Has anyone tried this? Are there some to...
I bought this car a few months ago. Turbo car built. Who ever did the wiring obviously messed something up. I had a no start issue where the theft light was flashing. Initially I thought it was a pats issue or a bad key. Had a locksmith come out and he confirmed that was not the issue. Well last...
Just bought a 96 GT and would love to have it running as best as it can. Im not loaded with money so these modifications can't be ridiculous and I'm also learning. Just wanna know the best way to increase power and acceleration. (Shes an automatic, btw.)
Thanks :)
P.S. Use laymans terms if...
I'm installing a Rockford Fosgate amp in my 1997 GT, and decided to follow their recommendations and use their wiring kit. It includes a heavy gauge power cable with inline fuse, which connects directly to the battery at the positive terminal. I've fastened the fuse holder to the top of the...
I have a 84 mustang with a stroker motor. Over the last week I noticed my radio would blackout when I either slowly rev or rapidly. It will come on within 15 seconds, but will blackout each time I accelerate. Don't matter if in gear or parked.
My battery has 12.6v prior to starting and 16.5v at...
I know the saying ...... opinions are like @$$holes, everyone has one .... but I'm looking for them anyway.
I have a 2007 Shelby GT500 with around 10K on her. I want it louder !!!!!
I know a cammer will never give me the sound of a pushrod motor, but I want to be heard!!
Upping horsepower...
In your opinion,what are your go to cams to recommend based solely on performance gain. Cyber Monday is upon us and I'm going to be ordering a set of cams. Her specs are below.