I installed a new Ram clutch and flywheel. The shop before left the transmission and flywheel unbolted by about 1/2 inch (roughly, the bolts have red Loctite, so within 47k miles, I don't think it backed out that much). I finished and drove around, and there's a rough shake at idle, and around...
I have a 1996 mustang gt, recently took it out and banged the gears. When coming to a stop sign the car wouldn’t go into gear but could get into 3rd gear only. No left or right play when clutch pressed or depressed even with car not running. You can force it into third but barely but will drive...
Okay, been chasing this issue for awhile, previous owner says its a rebuilt t5 with 5k miles on it. After driving it for a few months i was going about 50 dropped it to third and gave it hell. after that i had blown my coolant hose off and over heated. pulled over put it back on, took off and...
Hey everyone,
So the '90 LX 5.0 that I recently picked up had a whole hose of transmission issues with the T5 so I took it apart and have a few new questions. The symptoms were grinding going into every gear, with 1-2 being the worst and had to be perfectly rev-matched to let it into the gear...
Hey guys,
Kinda new to this forum but I have been restoring a 1984 Ford Mustang since November and I was in the final stages of just putting in a new clutch so the car would run smoothly and be able to handle any power we threw at it. After we installed the new clutch (Mcleod Stage 2), flywheel...
Fun T5 question for a 98 3.8L:
Leaking out rear of transmission where yoke enters. I can find an output seal easy enough, but I believe there is going to be "bushing" or "bearing" around the splines that I'll need to replace. Wondering if it's something I can do without dropping transmission. I...
World Class T5 for sale. Currently has a pro 5.0 shifter in it and an upgraded clutch however I cannot find any markings on the clutch. Transmission has about 10,000 miles on the rebuild. Located in Nolanville, TX. Asking $700.
Hey guys I have a 1987 fox with cold air intake and flow master exhaust system(putting 3:73 gears in soon) I want to build this car and make around 320 - 350 hp to the wheels. Could the stock trans handle these numbers? The car has 83,000 original miles and the engine and trans are strong...
Hey boys. I know this topic has probably been beat to death but I have a quick question. I have been going to the strip a couple times lately and I am less than satisfied with the 60' times I've been getting.
The car with gt40p's, explorer intake, xe270, LT's, offload H, 3.73s, tubular upper...
I have a T5 out of a 2000 v6 that I am trying to modify for use in a '93. I ordered the '93 input shaft and it came with the bearing on it, but no outer race. When I pulled the longer original 2000 input shaft out, the bearing was much smaller on it, and the retainer and race from the old shaft...
Hi Folks. I have a small issue I am needing advise on. I have a 67 ranchero with a 1990 5.0 HO and T5 trans. It is using the stock clutch linkage at the moment and this linkage has given me crazy issues. I ordered the cable clutch kit from CJ pony and I have notices that the small ear on the...