18x9 Bullitts w/ M2300K 5-lug?

[CoupedUp]

If the wheels don't fit with the bullitts, you can buy the brackets from North Race Cars to pull the rear wheels in 0.75" each side. You would need the Fox lenght 5-lug axles as well.

It would be $150 for the brackets + cost of new axles. You could recoop your cost by selling the cobra brackets and SN95 axles.

This would pull your rear wheels in slightly.

I've been looking into the same wheel setup and guys have suggested i do that instead of running the SN95 offset.

True .. I just wish more wheel companies would tailor to our foxes track and fender specs ... a but load of money to be made.

Take all the guess work and calculation out of it.

 

[CoupedUp]

The backspacing should be nothing to worry about, because .03 is hardly a difference.

I clicked the link in your sig and was looking over your car ...
Appears the passenger side rear sticks out a little more than the driver side??
Also, are those factory Ford Cobra R's? And if so, the R50's or the R58's??

Thanks again jb

 

[twolo4u2c2]

so your saying if I run 36mm offset I can run 9" wide wheels on all for corners with 01 cobra brakes?

 

[Mustang5L5]

You running 94-95 spindles or the '01's spindles?

 

[twolo4u2c2]

01 spindles