SOLD 1982 Mustang Notchback 351w

Status
Not open for further replies.

N8dogg2669

New Member
Aug 4, 2014
0
0
0
1982 Mustang LX Notchback (Turnkey needs nothing)
Curry Brown - Zero Rust
Original 5.0L/ 4 Speed Car
Original Paint
87-93 Quarter Windows (have original windows and trim in excellent shape)
351 Windsor - .30 over
Comp Cam
Pro Topline Aluminum Heads
Crane Gold Roller Rockers
Edelbrock Air-Gap Intake
Barry Grant 750 Demon Carb
Hooker Longtube swap headers
Custom built x-pipe (Reiters Metalcraft, Mt. Clemens, MI)
MAC Over the Axle tips (Beautiful and shiny)
Hardened Pushrods
Edelbrock Water Pump
ARP Bolts
Canton Oil Pan
Brand New MSD 6AL Ignition w/Coil
T-5 with Steeda Tri-Ax Shifter
Steeda Adjustable Clutch Quadrant
RAM Clutch
Aluminum Driveshaft/ Loop
8.8 Rear end
3.73 gears
KYB Shocks
MAC Upper/Lower Control Arms
Brand New Poly Bushings
Bullitt Springs on all 4 corners
BBK Subframe connectors
Full interior
Pioneer Headunit/ JL Auto Speaker
Shift Light
A Pillar Gauges (Oil/Temp)
4 Point Roll Bar
Car currently has Weld's on the front and a newer set of MT 255-60-15 Drag Radials on a set of 10 Holes. (Comes with a set of slicks that were never put on)
Numerous other parts come with the car that can be discussed with serious buyers (79-86 Windows/Trim, A set of Weld rims, heater core, headers, etc). Pictures do not do this car justice and it is a head turner everywhere it goes. Looks great and sounds great. This car has been babied it's whole life, garage kept, no rain, no snow. $10K OBO, willing to entertain trades on a Chevy Silverado C10 1974-83 only, nothing else. Please email [email protected] for any questions. Located in Macomb, MI. Call 586-703-2160 with any questions, ask for Nate.

car cover.jpg
car interior.jpg
car engine.jpg
 
  • Sponsors (?)


Car is still for sale, this is my cousins car. He is not too computer savy so I am helping him post it online. I believe it made 300/350 with the old cam. I am pretty sure he has not dyno'd it since. He ran a 12.30 1/4 mile with it right after the new cam install. The car still has a lot left in it, but I will find out dyno numbers if he has them and post them. Thanks for looking.

Edit: Just spoke to him, he does not have new dyno numbers since the new cam was installed.
 
Last edited:
Status
Not open for further replies.