9 inch wheels should have nothing bigger than 275's.
You will get too much sidewall flex with 315's and your handling will suck.
depends on what brand of 315. nitto drag radials fit, but BFG drag radials dont.
So what would you suggest? getting some deepdish out back if I wanna go with that large of a tire?
That is exactly what I was looking at, the Nitto555 D/R on American Muscle
So what would you suggest? getting some deepdish out back if I wanna go with that large of a tire?
That is exactly what I was looking at, the Nitto555 D/R on American Muscle
So what would you suggest? getting some deepdish out back if I wanna go with that large of a tire?
If you want that really fat tire look get some 10.5 rear wheels. I stick with the
9 inch wheels with 275's so I can rotate since I do a lot of highway miles.
That is exactly what I was looking at, the Nitto555 D/R on American Muscle
what car is it going on if its an IRS cobra you will want a 10.5in for a 315 to look good but you may have issues with tire rub on the rear suspension bolts so you will want to order some low profile bolts from Maximum Motorsports if you have this problem.
Does anyone have a pic of a 315 nitto on a 9 inch wheel (17's of course).
Ask and ye shall receive - see attached.
As stated, the 315/35 - 17 fit on the 9" rims very easily. They have a touch of bulge on the sidewall as seen in the pic, but that just ends up protecting your rims from curb rash.
These rims are 17X9 Cobra knockoffs.
Do you run spacers on the rears or anything? If so, did you have to roll the fender lip?
I was thinking that same exact thing, and I've BFG 275's.Damn....... My 275's look about the same as those 315's
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?