351w valve clearance??

h8my408

Member
Aug 27, 2007
93
0
7
Houston, Tx
i have a stock 351w from a 92 bronco and i just purchased the edelbrock top end rpm kit. the valves are 2.02 and 1.60.. i dont remember the specs on the cam, but if i remember correctly it's around .564 and the duration is retarded for a higher rpm powerband... im more than likely going to have to clay the motor, but if i cannot run the valves on the stock bottom end, im going to leave stock heads on for now. any help would be greatly appreciated...


-h8
 
i called summit today, because edelbrock was already closed, and summit didnt know.:shrug: :bang:

im calling edelbrock next. maybe they know what they designed. even then, i still have to take the heads off anyway. if there IS slap, the bottom end will be growing sooner than the planned later. bwa hahaha...