I've post about this before but I have a more specific question this time. I put in a 3G alt several months after I purchased my car because of the stereo equipment I planned to install. When I did the job I had little experiance with turning a wrench so I bumbled my way through the process. In the end I got it installed and everything ran so I left it at that. It seemed to charge great when it was cold but as it warmed up the charge needle would start to dip below the large tick on the guage. At running temp the needle would get down to one or two ticks above the red zone and bounce around a lot with the idle. I was expecting better performance considering the only drainage I added to the system was a set of 10" woofers with a 300W amp (no electric fan, stock fuel pump, etc...) Now Ive been having idle problems for quite some time, searching idle, wants to die at start-up, that kind of stuff. I've gone through almost all of the suggestions in the Idle Sticky with little success, could the stock power and ground wiring be my problem or should I start replacing stuff like the TPS and Salt and Pepper shakers? BTW what kind of charge SHOULD I be getting with this 130A alt? Should it be pegged out all the time considering I only have a stereo to draw extra power? Thanks for the input fellas. 
::EDIT:: In case you didnt catch the drift, I never put in the 4guage wire that people suggest. I just cut the wires at the connector and spliced them into the 3g connectors.
::EDIT:: In case you didnt catch the drift, I never put in the 4guage wire that people suggest. I just cut the wires at the connector and spliced them into the 3g connectors.

amnit: Leave it to me to make an easy job hard.