I've been working on these for a little while. I am testing out the jigs and these were a little off. There is only one bad spot in bod headers. One primary hangs a little low and may hit the crossmember at the bottom right where the motor mounts to the frame. Not bad, and they still mount, but not perfect. I've left them without v-bands to keep your cost down as they are going cheap. I'll try to get pics of the actual finished products up here. For now, these are the mock ups. http://www.theturboforums.com/smf/index.php?topic=83166.0
1/2 in flanges and 1 5/8 primary into 2.5...all MS I can add v-bands if you want. price is 400 plus shipping.
You need to trim one tab on the block above the oil filter. Ford used it for casting, but is not needed anymore.A oil filter adapter is also needed.
1/2 in flanges and 1 5/8 primary into 2.5...all MS I can add v-bands if you want. price is 400 plus shipping.
You need to trim one tab on the block above the oil filter. Ford used it for casting, but is not needed anymore.A oil filter adapter is also needed.
